IBM CT-618, Руководство по установке

Страница: 30 / 84

Upgrade Installations
IBM CTS Installation Guide 24
a) Check box to install Telephony Services Administration (required for
security level 2).
b) Select destination directory.
c) Your server name will be displayed. The installer will verify locations
and search for older versions of files. When complete, click Close.
d) The Configuration Assistant will appear, detecting any CT-618 boards
installed in the server and the resources used. (You may wish to make a
note of these resource assignments.) Click OK.
10. IBM VoiceMaster installation provides options for IBM VoiceMaster and
Voice Files. If you want to retain customized dialog files, un-check the Voice
Files selection box.
11. When setup successfully completes, click Close.
12. Power down the server.
13. Upgrade the CT-618 board firmware:
Note: If your server is set up as NTFS: During the board firmware update
process you will need to run in DOS mode. Since NTFS is not visible from
DOS, you will need to access required files from a FAT partition or a
diskette. If you are not installing the IBM Telephony software to a FAT
partition, you will need to copy the following files from the
IBMCT/SYSTEM folder to a FAT partition (or to a diskette):
BOOTLOAD.HEX, MONITOR.HEX, NETPHO32.HEX and NL.EXE.
a) Restart the server in DOS. (Note: A DOS window will not work.) You
may need to boot with a DOS boot disk if your server is not set up to
boot in DOS.)
b) Go to C:/IBMCT/SYSTEM (or the drive you selected during
installation) and enter the following command from the DOS prompt:
NL -B -LNETPHO32.HEX
This loads the firmware using default I/O port and IRQ settings (I/O
Port 3e0, IRQ 5). If not using these defaults, refer to Specifying and
changing board settings on page 31 for instructions on specifying
values in this command, or enter NL -? at the DOS prompt for help
with NL commands.