IBM BladeCenter JS20, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 100 / 218

Note: These checkpoint codes are described in Chapter 7, “Diagnostics,” on
page 37.
17. Reset the system date and time through the operating system that you
installed. For additional information, see your operating-system documentation.
The system-board assembly replacement procedure is now complete. Continue
with “Input/output connectors and devices” on page 92.
Completing the installation
To complete the installation, perform the following tasks, if you have not already
done so.
1. Install the blade-server bezel assembly on the blade server (see “Installing the
blade-server bezel assembly”).
2. Close the blade server cover (see “Closing the blade server cover” on page 92).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
3. Reinstall the blade server into the BladeCenter unit.
4. Turn on the blade server (see “Turning on the blade server” on page 13).
5. After you replace the battery or the system-board assembly, reset the system
date and time through the operating system that you installed. For additional
information, see your operating-system documentation.
Note: If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you will have to wait until the power-on LED on the blade
server flashes slowly before pressing the power-control button on a blade
server.
Installing the blade-server bezel assembly
The following illustration shows how to install the bezel assembly on the blade
server.
90
BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide