IBM 9114-275 - IntelliStation POWER 275, Руководство по установке, Страница: 89 / 102

Appendix E. General Attributes Required When Using a TTY
Terminal
The following general attributes are the default settings for the diagnostic programs. Be sure your terminal
is set to these attributes.
Note: Set these attributes before the diagnostic programs are loaded.
General Setup Attributes
3151
/11/31/41
Settings
3151 /51/61
Settings 3161 /3164
Settings
Description
Machine mode 3151 3151 PC 3161 or 3164 The diagnostic programs are set to
emulate use of the 3161 ASCII Display
Terminal. If your terminal can emulate a
5085, 3161 or 3164 terminal, use these
attribute settings. Otherwise, refer to your
operator’s manual, compare the attribute
descriptions with those of your terminal,
and set your attributes accordingly.
Generated Code Set ASCII
Screen Normal Normal Uses the EIA-232 interface protocol.
Row and Column 24 x 80 24 x 80 Uses the EIA-232 interface protocol.
Scroll Jump Jump Jump When the last character on the bottom
line is entered, the screen moves down
one line.
Auto LF Off Off Off For the
″
On
″
setting, pressing the Return
key moves the cursor to the first
character position of the next line. For the
″
Off
″
setting, pressing the Return key
moves the cursor to the first character
position of the current line. The CR and
LF characters are generated by the New
line setting.
CRT saver Off Off 10 The
″
10
″
setting causes the display
screen to go blank if there is no activity
for 10 minutes. When the system unit
sends data or a key is pressed, the
screen contents display again.
Line wrap On On On The cursor moves to the first character
position of the next line in the page after
it reaches the last character position of
the current line in the page.
Forcing insert Off Off
Tab Field Field Field The column tab stops are ignored, and
the tab operation depends on the field
attribute character positions.
Trace All Both inbound data (data to the system
unit) and outbound data (data from the
system unit) to and from the main port
can be transferred to the auxiliary port
without disturbing communications with
the system unit when the Trace key is
pressed.
73