IBM 8835 - Eserver 325 - 1 GB RAM, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 72 / 164

Baseboard management controller
Complete the following steps to remove the baseboard management controller. This
component is located in the rear of the server, on the same side as the power
supply.
Note:
v
Read “Installation guidelines” on page 25.
v
Read the safety notices at “Safety information” on page 101.
v
Read “Handling static-sensitive devices” on page 25.
1. Turn off the server and any attached devices.
2. Disconnect power cords and external cables from the back of the server.
3. Remove the server from the rack.
4. Remove the cover (see “Removing the cover and bezel” on page 27).
5. Locate the SO-DIMM connector (J16) on the system board (see “System-board
option connectors” on page 67).
6. Disengage the two retaining clips that secure the baseboard management
controller to the system board.
7. Gently grasp the baseboard management controller and pull it until it comes
loose from the SO-DIMM connector (J16) on the system board.
Plastic
standoff
8. Gently pull up on the baseboard management controller until it disengages
from the plastic standoffs. If the standoffs come away from the system board
with the baseboard management controller, gently pull them out of the
baseboard management controller and push them back into their apertures on
the system board.
Note: You can also gently pinch the top of each standoff using needle-nose
pliers and then pull the baseboard management controller away.
62
Eserver
325 Type 8835: Hardware Maintenance Manual and Troubleshooting Guide