IBM 8835 - Eserver 325 - 1 GB RAM, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 44 / 164

Working with a hard disk drive
This section describes the types of hard disk drives that the server supports and
other information that you must consider when installing a hard disk drive, as well
as how to install a hard disk drive in the server. Before you install a hard disk drive,
review the following information:
v
The server supports two 25.4-mm (1-inch), slim, 3.5-inch hard disk drives. SCSI
models of the server come with a hot-swap SCSI backplane.
v
The SCSI server models support low voltage differential (LVD) hot-swap drives.
Each hot-swap drive is in a tray, which has a green activity LED and an amber
status LED in the upper-right corner. These LEDs are lit if the drive is active and,
in some cases, if the drive fails. Each hot-swap drive has a single-connector-
attached (SCA) connector, which is connected directly into the hot-swap SCSI
backplane. The backplane attaches to connector J12 on the system board and
controls the SCSI IDs for the hot-swap drives.
Note: The drive in bay 1 is assigned SCSI ID 0; the drive in bay 2 is assigned
SCSI ID 1.
v
A non-hot-swap hard disk drive does not require a backplane or tray and it does
not have indicator LEDs. However, you must attach the blue rails that come with
the drive before installing it in the server.
v A non-hot-swap hard disk drive has a jumper block on the rear. Install a jumper
in the cable-selection position of the jumper block. For details, see the notes
under step 4 on page 36, and the documentation that comes with the drive.
v
If you install only one hard disk drive, for faster startup, install it in the primary
startup device bay. For hot-swap SCSI drives, the drive in bay 1 is the primary
startup device. For IDE drives, the drive in bay 2 is the primary startup device.
v If you are installing a hot-swap drive, continue with “Installing a hot-swap hard
disk drive” on page 35. If you are installing a non-hot-swap drive, go to “Installing
a non-hot-swap hard disk drive” on page 36.
34
Eserver
325 Type 8835: Hardware Maintenance Manual and Troubleshooting Guide