IBM 8835 - Eserver 325 - 1 GB RAM, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 57 / 164

Completing the installation
Complete the following steps to complete the installation:
1. Position the internal cables so they do not interfere with the cover installation.
Attention: Before sliding the cover forward, make sure that all the tabs on
both the front and rear of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be very difficult to remove the cover
later.
2. Position the cover on top of the server and slide it forward. Press down on the
cover latch. The cover slides forward into position. Ensure that the cover
engages the tabs at the front and rear of the server.
3. If you removed the bezel, position the bezel directly in front of the server and
press it into place so that the retention tabs snap into the holes on the top, right
side, and bottom of the server.
4. If you removed the USB option tray, insert it fully into the slot below hard disk
drive bay 1.
5. Install the server in the rack and connect all external cables; then, connect the
power cord. For details, see the Rack Installation Instructions that come with the
server.
Notes:
a. Depending on the options that you installed, after cabling the server, you
might need to run the Configuration/Setup Utility program to update the
server configuration. For more information, see “Updating the server
configuration” on page 48 and the User’s Guide on the IBM
Eserver
Documentation CD.
b. If you installed a SCSI drive, check the LEDs to verify proper operation.
6. To attach peripheral devices and connect the power cord, continue with
“Connecting the cables” on page 48.
Chapter 4. Installing options
47