IBM 8203-E4A, Руководство пользователя

Страница: 15 / 82

v
For a rack-mounted system, see “Installing the front cover on a rack-mounted 8203-E4A, 8204-E8A,
8261-E4S, 9407-M15, 9408-M25, or 9409-M50” on page 37.
v
For a stand-alone system, see “Installing the front cover on a stand-alone 8203-E4A, 8204-E8A,
8261-E4S, 9407-M15, 9408-M25, or 9409-M50” on page 39.
7. If you replaced the control panel as part of another procedure, return to that procedure now. If you
replaced it because it was not operational, verify that the new resource is functional. See “Hardware
service manager Verify option” on page 52.
8. Start the system. See “Starting the system or logical partition” on page 27.
Note: If there is a ball or dot that appears in the middle of the control panel, toggle between function
02 and function 01 until the graphic disappears.
Related information
Exchange a part using the Hardware Management Console
Removing and replacing the 8203-E4A, 8204-E8A, 8261-E4S, 9407-M15,
9408-M25, or 9409-M50 control panel fillers
You can remove or replace the control panel filler from the server.
Attention: If you do not replace the control panel immediately after removing it, a control panel filler
must be in place for proper air flow and cooling when the system is powered on.
Removing the control panel filler
To remove the control panel filler, do the following steps:
1.
Remove the front cover.
v
For a rack-mounted system, see “Removing the front cover from a rack-mounted 8203-E4A,
8204-E8A, 8261-E4S, 9407-M15, 9408-M25, or 9409-M50” on page 36.
v
For a stand-alone system, see “Removing the front cover from the stand-alone 8203-E4A, 8204-E8A,
8261-E4S, 9407-M15, 9408-M25, or 9409-M50” on page 38.
2. Locate the control panel filler.
3. Remove the control panel filler by pressing the locking tabs located on either side of the filler,
grasping the edges of the panel, and pulling it out of its bay.
Replacing the control panel filler
To replace the control panel filler, do the following steps:
1.
Carefully slide the control panel filler into the control panel bay until you feel the locking tabs lock in
place.
2. Replace the front cover.
v
For a rack-mounted system, see “Installing the front cover on a rack-mounted 8203-E4A, 8204-E8A,
8261-E4S, 9407-M15, 9408-M25, or 9409-M50” on page 37.
v For a stand-alone system, see “Installing the front cover on a stand-alone 8203-E4A, 8204-E8A,
8261-E4S, 9407-M15, 9408-M25, or 9409-M50” on page 39.
Removing and replacing the 8203-E4A, 8204-E8A, 8261-E4S, 9407-M15,
9408-M25, or 9409-M50 control-panel signal cable
You can replace the control-panel signal cable on the server.
Chapter 1. 8203-E4A, 8204-E8A, 8261-E4S, 9407-M15, 9408-M25, or 9409-M50 control panel
7