IBM 8203-E4A, Руководство пользователя

Страница: 46 / 82

Removing the door from the 8204-E8A or 9409-M50
Use this procedure to remove the door to access components or perform service.
1. Open the front door by grasping the door handle and pulling the door out and away from the system
unit.
2. To remove the door, press down on the top back edge of the door.
3. Gently swivel the top back edge of the door forward and out past the top of the system unit.
4. Lift the door up to release it from the lower retaining post.
Installing or replacing the door on the 8204-E8A or 9409-M50
Use this procedure to install the door after accessing components or performing service.
1.
Set the door on the lower retaining post.
2. Rotate the door toward the top of the system unit.
3. Press down on the lower back edge of the door, and seat the top post into its matching slot.
4. Close and secure the door.
Removing the front cover from the stand-alone 8203-E4A, 8204-E8A,
8261-E4S, 9407-M15, 9408-M25, or 9409-M50
Use this procedure to remove the cover to access components or perform service.
1. Open the door that covers the disk drives by unlocking and pulling the door open.
2.
Press down on the cover-release tab (A) as shown in the following figure.
3. Pull the top of the cover (B) out and away from the system.
Figure 27. Installing the front cover on a rack-mounted model
38
Control panel, control panel fillers, and signal cables