IBM 8038, Инструкция по установке и эксплуатации

Страница: 74 / 104

v
If you install a different type of RAID controller, see the documentation that
comes with the controller for information about viewing and changing settings
for attached devices.
Starting the LSI Configuration Utility program
Use these instructions to start the LSI Configuration Utility program.
To start the LSI Configuration Utility program, complete the following steps:
1. Turn on the blade server, and make sure that the blade server is the owner of
the keyboard, video, and mouse.
2.
When the
<<<Press Ctrl-C to start LSI Logic Configuration Utility>>>
prompt is displayed, press Ctrl+C.
3. Use the arrow keys to select the controller from the list of adapters; then, press
Enter.
4.
Follow the instructions on the screen to change the settings of the selected
items; then, press Enter. If you select
SAS Topology or Advanced Adapter
Properties , additional screens are displayed.
When you have finished changing settings, press Esc to exit from the program;
select
Save to save the settings that you have changed.
Note: For more information, see the Installation and User's Guide for ServeRAID
H1135 at http://www-947.ibm.com/support/entry/portal/
docdisplay?lndocid=MIGR-5088601&brandind=5000008.
Starting the Human Interface Infrastructure (HII) Configuration
Application
Use these instructions to start the HII Configuration Application.
To start the HII Configuration Application, complete the following steps:
1. Turn on the blade server, and make sure that the blade server is the owner of
the keyboard, video, and mouse.
Note: Approximately 20 to 40 seconds after the server is connected to power,
the power-control button becomes active.
2.
When the prompt
<F1 Setup>
is displayed, press F1. If you have set an
administrator password, you are prompted to type the password.
3. Select System Settings
→
Storage .
4. Under Storage , select the ServeRAID adapter you want to configure and press
Enter to continue.
When you have finished changing settings, press Esc to exit from the program;
select
Save to save the settings that you have changed.
Note: For more information, see the Installation and User's Guide for ServeRAID
H1135 at http://www-947.ibm.com/support/entry/portal/
docdisplay?lndocid=MIGR-5088601&brandind=5000008.
Creating a RAID array of hard disk drives
Use this information to create a RAID array of hard disk drives.
To create a RAID array of hard disk drives, complete the following steps:
60
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide