IBM 8038, Инструкция по установке и эксплуатации

Страница: 38 / 104

The blade server has two storage bays for installing hot-swap storage drives. One
storage drive might already be installed in the blade server in storage bay 0. If the
blade server is equipped with one storage drive, you can install an additional drive
in storage bay 1. The blade server supports using RAID 0 or RAID 1 when two
storage drives of the same interface type are installed. See “Creating a RAID array
of hard disk drives” on page 60 for information about SAS RAID configuration.
To install a hot-swap storage drive or drive filler, complete the following steps.
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 17.
2. Identify the storage bay (storage bay 0 or storage bay 1) in which the hot-swap
storage drive will be installed (see “Blade server connectors” on page 15).
3.
If a storage-drive filler is installed, remove it from the blade server by pulling
the release lever and sliding the filler away from the blade server (see
“Removing a hot-swap storage drive”).
4. Touch the static-protective package that contains the hot-swap storage drive to
any
unpainted metal surface on the BladeCenter unit or any unpainted metal
surface on any other grounded rack component; then, remove the hard disk
drive from the package.
5. Open the release lever on the hot-swap storage drive and slide the drive into
the storage bay until it is firmly seated in the connector.
6. Lock the hot-swap storage drive into place by closing the release lever.
If you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 43.
Removing a hot-swap storage drive
Use this information to remove a hot-swap storage drive.
The blade server has two hot-swap storage bays for installing or removing
hot-swap storage devices. To remove a hot-swap hard disk drive or drive filler,
complete the following steps.
24
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide