IBM 8038, Инструкция по установке и эксплуатации

Страница: 52 / 104

2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 19 for instructions).
3.
Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see “Removing the blade server cover” on page
20 for instructions).
5. Locate the CFFh expansion card. The CFFh expansion card is installed into the
blade expansion connector (see “Blade server connectors” on page 15).
6. Open the expansion-card standoff.
7. Lift the release lever to disengage the CFFh expansion card from the expansion
connector on the system board.
8.
Use your fingers to hold the edge of the CFFh expansion card where it
connects to the blade expansion connector; then, lift up on the card.
Installing a horizontal-compact-form-factor expansion card
Use these instructions to install a compact-form-factor expansion card in the blade
server.
The blade server supports a horizontal-combination-form-factor (CFFh) expansion
card. The following illustration shows how to install a CFFh expansion card.
Attention: If the expansion card is not running at the speed supported by the
card, you can change the maximum speed of the PCIe bus in the Setup Utility by
selecting
System Settings and Devices and I/O Ports .
To install a CFFh expansion card, complete the following steps:
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 17.
2. If the blade server is installed in a BladeCenter unit, remove it (see
“Removing the blade server from the BladeCenter unit” on page 19 for
instructions).
3. Carefully lay the blade server on a flat, static-protective surface.
4. Remove the blade server cover (see “Removing the blade server cover” on
page 20).
5.
If an optional expansion unit is installed, remove the expansion unit (see
“Removing an optional expansion unit” on page 23).
38
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide