IBM 3455-D3E, Инструкция по установке

Страница: 28 / 46

© Copyright IBM Corporation 2019, 2020, 2021 Customer Install Guide, 1U Chassis 28
Slide the enclosure into the rack
Engaging and Releasing the Slam Latch
NOTE: For systems not equipped with slam latches, secure the system using screws, as
described in step 3 of this procedure.
Facing the front, locate the slam latch on either side of the system ( 1 ). The latches engage
automatically as the system is pushed into the rack and are released by pulling up on the latches
( 2 ). To secure the system for shipment in the rack or for other unstable environments, locate the
hard-mount screw under each latch and tighten each screw with a #2 Phillips screwdriver ( 3 ).
Figure 10. Enclosure installation
Install the cable management arm
NOTE:
These management arms are an integral component of the system
design. Their use is critical for effective installation, for reliability of operation and for
ease and effectiveness of service. The cable management arms allow for orderly
routing of cables in system racks; they enable individual server enclosures to be slid out
on rails while powered and operating, minimizing disruption and system outages and
simplifying service operations. For these reasons and more, the cable management
arms are required. Should you choose not to install the management arms, IBM will not
be able to install or support your Cloud Pak for Data System. Should they be removed