IBM 3455-D3E, Инструкция по установке

Страница: 27 / 46

© Copyright IBM Corporation 2019, 2020, 2021 Customer Install Guide, 1U Chassis 27
Install the enclosure on the slide rails
Note:
This unit weighs approximately 49lb (22kg). IBM recommends the use of an
appropriate lifting device to position the chassis on the rails.
Installing the System in a Rack
Pull the inner slide rails out of the rack until they lock into place ( 1 ). Locate the rear rail standoff
on each side of the system and lower them into the rear J-slots on the slide assemblies ( 2 ).
Rotate the system downward until all the rail standoffs are seated in the J-slots ( 3 ). Push the
system inward until the lock levers click into place. Press the slide-release lock buttons on both
rails and slide the system into the rack ( 4 ).
Figure 9. Enclosure Installation
Attention: You can only install the enclosure successfully when the slides are
fully extended.