IBM 3000 6.0.2, Руководство по обслуживанию

Страница: 57 / 88

# mmshutdown -N <Node server names separated by a comma>
a. Ensure that the node servers associated with the target ESS 3000 are shut down by issuing the
following command:
# mmgetstate -a
4. Pull power cables that are connected to the ESS 3000 system (SSR task).
a. Confirm with customer to ensure that customer did all required steps, and then disconnect the
power cables.
b. To shut down the storage enclosure, unplug both power cords that are on both the sides of the
ESS 3000 system.
5. For MES memory installation, do the following steps (SSR task).
a. Pull out the ESS 3000 from the frame.
b. Open each canister.
c. Insert the additional DIMMS into each canister.
For more information about these steps, see the IBM Elastic Storage System 3000: Service Guide
or the Planning for hardware chapter of the IBM Elastic Storage System 3000: Hardware Planning
and Installation Guide.
6. Power on ESS 3000 and do basic checks (SSR task).
a. After basic checks completion, place everything back into the frame and reinsert power cables.
This step restarts the nodes.
You can use the procedure in the Installing chapter of the IBM Elastic Storage System 3000:
Hardware Planning and Installation Guide to do the following steps:
i) Plug your laptop to point-to-point to each container technician port.
ii) Log in as essserv1 .
iii) Run the essutils command.
b. In the essutils command, use the SSR tools option to run the following option on each canister:
• Option #6. Check the memory
Running: /opt/ibm/ess/tools/bin/ess3kplt -t memory –local
ESS3K Mem Inspection:
InspectionPassed: True
Total Available Slots: 24 (expected 24)
Total Installed Slots: 24 (expected 12 or 24)
DIMM Capacity Errors: 0 (Number of DIMMs with a size different from 32 GB)
DIMM Speed Errors: 0 (Number of DIMMs with a speed of neither 2400 nor 2666
MT/s)
Inspection DateTime: 2020-02-19 15:50:41.031501
Press Enter to continue...
The key here is the Total Installed Slots should now be ‘24’ and the
InspectionPassed: True
i) Check the memory of each canister.
ii) If any issues, go back to the main page of essutils -> Advanced Tasks -> Check the memory.
This option dumps the complete list of DIMMs in each slot.
7. Configure GPFS page pool size to the 60% target (customer task).
Find the node class name to use, and list the current pagepool settings by issuing the following
commands from either one of the server canisters:
# mmvdisk nc list
Chapter 2. Servicing 45