IBM 3000 6.0.2, Руководство по обслуживанию

Страница: 31 / 88

Chapter 2. Servicing
Service information is intended for IBM authorized service personnel only. Consult the terms of your
warranty to determine the extent to which you can attempt to accomplish any IBM ESS 3000 system
maintenance.
IBM service support representatives and lab based services personnel can access service information
through the following link.
Servicing (service personnel only)
Note: An IBM intranet connection is required.
Removing and replacing a drive
Use the following procedures to remove a faulty drive from a server canister and replace it with a new one
from stock.
Attention:
• When you replace this part, you must follow recommended procedures for
handling electrostatic discharge (ESD)-sensitive devices.
• No tools are required to complete this task. Do not remove or loosen any screws.
• This procedure requires access to either management GUI or CLI command as a root user. IBM
service personnel need to coordinate with the customer to work on this procedure.
• You can identify the failed drive by the amber fault LED on the drive carrier. If the fault LED is lit
on a drive, it is safe to replace the drive.
You can also locate unhealthy drives in the management GUI, either from the Storage > Physical
Disks page or from the list of events that are available under the Monitoring > Events page.
You can also select the Display unhealthy devices option in the Monitoring > Hardware Details
page to see all the unhealthy devices including the faulty disks.
• Every drive slot of an operational control enclosure must contain either a drive or a blank filler,
and must not be left empty for more than 10 minutes during servicing. Ensure that you have read
and understood all these instructions and have the replacement drive available and unpacked
before you remove the existing drive.
• During the replacement process, the replacement drive is automatically checked to confirm if it
is a valid FRU and has the same capacity as all other drives in this system. The drive firmware will
be automatically upgraded, if required.
Safety preparation
Read the safety precautions in the IBM Systems Safety Notices. These guidelines help you safely work with
the system.
Removing the drive
In ESS 3000 system, a faulty drive has amber fault LED ON (non-flashing) on the driver carrier. You can
remove a drive using either the management GUI or using the CLI commands.
• Option 1. Removing a drive using management GUI
To replace disks using the management GUI, follow the direct maintenance procedure (DMP) that is
available in the Replace disks topic in the Elastic Storage Server 5.3.5: Problem Determination Guide.
• Option 2. Removing a drive using CLI commands
©
Copyright IBM Corp. 2019, 2021 19