IBM 2027-R04, Инструкция по установке и обслуживанию

Страница: 47 / 116

23 Chapter 2: Installing and connecting the SAN Router
mask = subnet mask of the network management subnet.
gateway = IP address of the gateway router. The gateway router
is a directly connected router to which management traffic should
be forwarded.
5. Save the configuration using the CLI:
• At the command prompt enter:
save
6. Reset the system using the CLI:
• At the command prompt enter:
reset system
The management IP address is now set and ready for normal
out-of-band management. If you choose to continue configuring the
SAN Router using CLI, please see the
E/OSi Command Line Interface for
IBM TotalStorage User Manual
.
Task 7: Initiating the Element Manager
1. Connect the standard RJ45 Cat 5 Ethernet cable from the LAN to
the 10/100 management port (RJ45). See Figure 4 on page 21.
• Wait for the SAN Router to come up (watch for the link LED to
light).
NOTE:
The link LED is located next to the RJ45 connector. A steady light
means the port is active and a blinking light means there is traffic.
2. Ping the IP address you entered in Task 6 to verify network
connectivity using the network management host.
• If there is no ping response, contact your network
administrator to set up connectivity between the network
management station and the SAN Router.
You are now ready to configure the SAN Router using the Element
Manager.
Before you connect the SAN Router to the network
You have set the network management IP address to suit your
network environment. The SAN Router is also shipped with a default