i
6
OIM AI-7X82D V2.1 Page 6 of 10
This parameter will appear only if Control logic is Heat-Cool.
If Enabled, User can set Diff. mode for OUTPUT 2 in USER list.
If disabled, User can not set Diff. mode for OUTPUT 2 in USER list.
This parameter will appear only if Control logic is Heat-Cool.
OP2 will be OFF at A OP2C value irrespective of output 2 mode.
This parameter allows the user to select output 2 as an ‘Auxiliary’ control.
For options refer Table 3.
This parameter allows the user to select output 2 as an ‘Alarm’ control.
For options refer Table 4.
This parameter allows the user to select output 2 as a ‘Soak’ mode.
For options refer Table 5.
This parameter allows the user to select output 2 to function as both ‘Alarm’ &
‘Soak’. For options refer Table 4 & 5.
If Enabled, User can View & edit the Set point (SP1) in USER list.
If disabled, User can only View the Set Point (SP1) but Can not edit it in USER
list.
SET
POINT 1
OUTPUT 2
MODE
OUTPUT 2
CONTROL
OUTPUT 2
FUNCTION
Enable
Disable
15.0
Auxiliary
When NONE is selected, Output 2 will be permanently de-activated.
This parameter helps in selecting the functionality of Digital Input.
When NONE is selected, Digital Input will be permanently de-activated.
By selecting this parameter, Digital Input can be used as Water Level Indicator input.
By selecting this parameter, Digital Input can be used to detect whether the door is
open or closed.
By selecting this parameter, Digital Input can be used to start soak timer.
By pressing DOWN key, Lower display will Toggle between SP1-value, SP2-
value, Alarm SP-Value(AL.SP) & Timer-value(SOAK).
By this parameter Lower display will only show the SP1-value.
By this parameter Lower display will only show the Timer value(SOAK TIME).
By this parameter Lower display will show Setpoint till soak timer has not started
and afterwards, it will display the Timer value(SOAK TIME).
This parameter will appear only if Output 2 is set as SOAK/ AL.ST
Digital Input will be detected after selected timing.
The range of Digital Input timing will be from 0 to 99 sec.
Alarm output will be generated after the completion of alarm time and detection of
Digital Input.
The range of Alarm Input timing will be from 0 to 99 sec.
LOWER
DISPLAY
RAMPING
SETPOINT
If Enabled, User can View ramping setpoint.
This parameter will appear only if Ramp rate is enabled.
If disabled, User can View target setpoint.
This parameter will appear only if Ramp rate is enabled.
DIGITAL
INPUT
FUNCTION
DIGITAL
INPUT
TIMING
ALARM
INPUT
TIMING
LOWER
DISPLAY
MESSAGE
Enable
LWL
0 sec.
3 sec.
SP1
PARA
METER
LOWER
DISPLAY
UPPER
DISPLAY
DEFAULT
DESCRIPTION
AI-7682D
