I-Tech I-TECH 10000, Руководство пользователя

Страница: 28 / 44

IACER Srl 24 MNPG179
After setting all the parameters, press ENTER to tell the I-TECH
LA8000/10000 that all the parameters have been entered and the software
prompts the operator to press ENTER to start therapy. The I-TECH
LA8000/10000 then runs as indicated from step 4 in the previous section.
End of treatment
When the ENTER key and then the actuator are pressed, the LA8000 starts
the countdown TIMER. The counter and emission of the laser continue until:
•
the counter ends: in the case of a normal session of therapy, the
system triggers three long audible signals when the counter ends,
disables the laser, and returns to the main menu to await further
commands.
•
Safety timer: when the I-TECH LA8000/10000 is activated and ready
to emit the laser, it permits a pause (with the actuator not pressed)
of no more than 3 minutes. After this length of time, the device
disables the laser and returns to the main menu.
•
ENTER key: during therapy, the operator can end the session at any
time by pressing the ENTER key.
•
Laser Stop: it is possible to end therapy at any time by pressing the
emergency stop button, which shuts down the device completely.
Last 10 programs
The device stores in its internal memory the last 10 programs used; they can
be recall rapidly from the dedicated section in the main menu.
Setup
From the main menu select SETUP using the UP and DOWN and then ENTER
keys. This section allows the operator to:
•
CHANGE PASSWORD: following the instructions below, the device
permits to change the PIN:
−
showing in the lower part of the display the symbol “>0”,
the device requests to:
▪
insert the current password;
▪
insert the new password;
▪
insert the new password again to confirm.