9.3
VCF
It allows to use the LFO oscillator for command the cut frequency of the lowpass filter of the filter menu (see
11.0 Filters), The command can be done rotating the potentiometer nr. 3 (see 1.0 front panel).
If you want to make the VCF work you must enable the filter of the filter menu and setting up the cut
frequency of the “LowPass”.
When the potentiometer is at the minimum, the cut frequency don’t change, the more you turn up the
potentiometer the more the cute frequency change and it will be fast.
9.4
D/W
It allows to set up the effects’ quantity to add to the source signal, the command can be done rotating the
potentiometer nr. 4 (see 1.0 front panel). When the D/W is set on zero, the input signal will be the same as
the one in the output, then all effects won't be audible. When the D/W is at maximum, the input signal will
totally be over the effects and in the output, there will be only the processed signal.
This D/W general function is available in all the effects menu and in the Noise menu and it’s always
corresponding at the potentiometer nr. 4.
9.5
EXTERNAL SYNC
If a midi clock signal is available and the midi channel is configured to “EXTERNAL” in the controller menu
(see 25.0 Controller), the LFO phase will be set to zero whenever a beat midi clock is received.
10.0
Flanger
To get into the “Flanger” menu, make sure that the toggle switch is placed on the left (see 1.0 front panel),
then press once the encoder on the left of the display (the item “menu” will be highlighted) and afterwards
rotate it until it is placed on the required menu.
In the Flanger section the same effect’s setup can be managed. In the SX-I the effects can work
simultaneously. It is possible to edit the “Amount” (quantity of the effect to be added to the source), the
waveform time of flanger and the general “D/W” (quantity of the effect to be added to the source).
10.1
Amount
It allows to set up the Flanger’s quantity that should be added to the source signal. The command can be
done rotating the potentiometer nr. 1 (see 1.0 front panel). When the Amount is set on zero, the input signal
will be the same as the one in output, the effect won’t be audible, the more you turn up the potentiometer the
more the effect will be marked.
10.2
Tempo
The Flanger effect’s time can be varied rotating the encoder on the right of the display. Values vary from 0
seconds (the flanger oscillator doesn’t generate the sine wave of the effect) to 1.55 seconds.
10.3
D/W
It allows to set up the effects’ quantity to add to the source signal, the command can be done rotating the
potentiometer nr. 4 (see 1.0 front panel). When the D/W is set on zero, the input signal will be the same as
the one in the output, then all effects won't be audible. When the D/W is at maximum, the input signal will
totally be over the effects and in the output, there will be only the processed signal.
This D/W general function is available in all the effects menu and in the Noise menu and it’s always
corresponding at the potentiometer nr. 4.
11.0
FILTERS
To get into the “Filters” menu, make sure that the toggle switch is placed on the left (see 1.0 front panel),
Page
of
11
21
