7.0
Granular
To get into the “Granular” menu, make sure that the toggle switch is placed on the left (see 1.0 front panel),
then press once the encoder on the left of the display (the item “menu” will be highlighted) and afterwards
rotate it until it’s placed on the required menu.
In the Granular section the setup of the same effect can be managed. In the SX-I all the effects can work
simultaneously. It’s possible to edit the “Amount” (the effect’s quantity to add to the source), the type of the
granular sample (Pitch Shift or Freeze), the sample “Speed”, the sample “Length” and the general “D/
W” (quantity of the effect to be added to the source).
7.1
Pitch Shift / Freeze
It’s possible to change the granular type of sample rotating and pressing the encoder on the right of the
display. The item “Freeze or Pitch” is visible on the display, under the item “GRANULAR”.
7.2
Amount
It allows to set up the quantity of effect to be added to the source signal. The command is done rotating the
potentiometer nr. 1 (see 1.0 front panel). When the Amount is set on zero the input signal will be the same as
the one on output, so the effect won’t be audible. The more you increase the potentiometer the more the
effect will be marked. It’s possible to reset the amount instantly pressing the encoder on the right of the
display.
7.3
Speed
To set up the Speed it’s necessary to rotate the potentiometer nr. 2 (see 1.0 front panel).
It allows to set up the velocity of Granular sample.
7.4
Length
To set up the Length it’s necessary to rotate the potentiometer nr. 3 (see 1.0 front panel).
It allows to set up the Pitch or Freeze of sample legth. Pitch shift by continuously sampling grains and
playing them at altered speed.
7.5
D/W
It allows to set up the effects’ quantity to add to the source signal, the command can be done rotating the
potentiometer nr. 4 (see 1.0 front panel). When the D/W is set on zero, the input signal will be the same as
the one in the output, then all effects won't be audible. When the D/W is at maximum, the input signal will
totally be over the effects and in the output, there will be only the processed signal.
This D/W general function is available in all the effects menu and in the Noise menu and it’s always
corresponding at the potentiometer nr. 4.
7.6
OFF
This feature is available in SX-I Effector / Synthesizer MK2
PRO
version only.
It allows to mute the input signal of effects, this feature allows to play the natural sound effects evolution until
the end while the original input signal is active.
It’s possible to mute the effects pressing the encoder on the right of the display and the item “OFF” is visible
on the display. Press the encoder again to reactivate the input signal of the effects.
8.0
Bitcrusher
To get into the “Bitcrusher” menu, make sure that the toggle switch is placed on the left (see 1.0 front panel),
then press once the encoder on the left of the display (the item “menu” will be highlighted) and afterwards
rotate it until it is placed on the required menu.
Page of
9
21
