done rotating the potentiometer nr. 4 (see 1.0 front panel). This special effect creates all the tension you
need in your music. When the Cubed is set on zero, the input signal will be the same as the one in output,
the effect won’t be audible, the more you turn up the potentiometer the more the effect will be marked.
12.4
OFF
This feature is available in SX-I Effector / Synthesizer MK2
PRO
version only.
It allows to mute the input signal of effects, this feature allows to play the natural sound effects evolution until
the end while the original input signal is active.
It’s possible to mute the effects pressing the encoder on the right of the display and the item “OFF” is visible
on the display. Press the encoder again to reactivate the input signal of the effects.
13.0
COMPRESSOR
To go into the “Compressor” menu, make sure that the toggle switch is on the left (see 1.0 front panel), so
click one time the encoder on the left of the display (the item “menu” will be highlighted) and then turn it until
it is arranged in the required menu.
In the Compressor section, it is possible to change the value of the Auto Volume Control (AVC /
Compressor).
13.1
ON / OFF
It is possible to turn on or off the compressor pressing the encoder on the right of the display. The item “ON
or OFF” is visible on the display, under the item “COMPRESSOR”.
13.2
Pre / Post
It allows to set up the Compressor signal position to Pre (before effects) and Post (after effects).
13.3
Gain
It allows to edit the maximum gain that can be applied for expanding, and can take one of three values: 0dB,
6.0dB and 12dB.
To change this value it is necessary to be placed on the Gain, rotate the encoder on the right of the display
then press the same encoder once.
13.4
Resp
It allows to edit the integration time for the compressor and can take four values: 0ms, 25ms, 50ms or
100ms. Larger values average the volume over a longer time, allowing short-term peaks through.
To change this value it is necessary to be placed on the Resp, rotate the encoder on the right of the display
then press the same encoder once.
13.5
HardLim
It allows to edit the Hard Limit function, if hardLimit is OFF, a 'soft knee' compressor is used to progressively
compress louder values which are near or above the Threashold (the louder they are, the greater the
compression). If it is ON, a hard compressor is used (all values above the Threashold are the same
loudness).
To change this value it is necessary to be placed on the HardLim, rotate the encoder on the right of the
display then press the same encoder once.
13.6
Threshold
It allows to edit the threshold of the compressor, the command can be done rotating the potentiometer nr. 2
(see 1.0 front panel).
The value is in dBFS and can take from 0 to -60.
Page
of
13
21
