
14
Transmitting a Call
When transmitting a call, please follow steps below:
1. Hold down the
PTT
key on the microphone.
2. Speak into the microphone. The red LED lights during calling.
3. Release
the
PTT
key to return to the RX mode.
4. When the transmission ends, put the microphone on hook.
Selecting the Power Level
If the current channel is programmed with high power by your dealer, the power output toggles between
high and low upon each press of the programmed
Tx Power Select
key. The
L
O
icon is displayed on
LCD to indicate low power.
A lower power level saves battery and reduces the possibility of interference. Use the high power setting
only when necessary.
Note:
If the current channel is programmed with lower power, any
Tx Power Select
key press will prompt
an error tone, and the power level will not change.
If you switch to low power on a channel that was set with high power, this configuration will work on
all other channels that were set with high power.
BOT ID and EOT ID
Your dealer may configure whether to transmit Connect ID (BOT ID) and Disconnect ID (EOT ID), when
connecting or disconnecting a repeater or telephone system. The following modes are programmable:
1. Press
the
PTT
key, and the BOT ID is transmitted.
Release the
PTT
key, and the EOT ID is transmitted. .
2. Press
the
*
key while holding down the
PTT
, and the BOT ID is transmitted.
Press the
#
key while holding down the
PTT
, and the EOT ID is transmitted.