
9
Installation
Before you install the radio in a vehicle, be sure to read the following instructions carefully:
Instructions
z
The radio operates with negative grounded power supply of
13.6 ± 15
%
V
only. Please check polarity
and voltage of the power supply on vehicle before you install the radio.
z
Please check how long the screws will extend from the bottom surface of radio, before you install the
radio. Be sure to drill mounting hole with caution, to avoid damage of the vehicle wiring and parts.
z
Please connect the supplied antenna and power cord to the radio, before you install the radio in the
bracket.
z
Install the radio with HYT supplied mounting bracket, to avoid radio loose in case of accidents. The
loose radio may cause bodily injury.
z
Install the radio in a location where it’s easy to reach the front panel controls.
z
Please determine the location of mounting hole before drilling.
z
Please make sure there’s sufficient space at back of the radio for wiring.
z
When the fuse for DC power cord needs replacement, it must be replaced by a fuse with the same
specification.
Installation Tools
z
Electric drill: ¢6mm or above
z
Cross head screwdriver
z
Hex socket sleeve (used for mounting 4.8 × 20 mm self-tapping screw)
Installation Steps
1. Install the bracket in a location where it’s easy to operate the radio.
2. Connect accessories such as antenna and power cord to the radio.
3. Slide the radio into the mounting bracket and secure it using the locking knobs.
4. Install the microphone hanger in a location where it’s easy to reach the microphone.
5. Plug the palm microphone into the microphone jack on the front panel, and place it on the hanger
when you do not use it.