Hypertherm SmartSYNC 059719, Руководство по процедурам

Страница: 47 / 98

Hand Torch Part Replacement Procedures
4
SmartSYNC Service Parts and Procedures 810460 47
3. Remove the wires from the 2-pin receptacles on the RF torch PCB. One wire at a time, push the
lever on the 2-pin wire receptacle while you pull the wire straight out of the receptacle. It can be
necessary to use some force, or push the wire into the receptacle before you pull it out. Refer to
Figure 4 on page 47 for location.
a. Remove the blue and black cap-sensor switch wires from the receptacle.
b. Remove the 2 red RF wires from the receptacle.
Figure 4 – RF torch PCB connections for hand torch
4. Put the RF torch PCB in an anti-static container, unless you are replacing the RF torch PCB.
5. Remove the pilot terminal screw.
1
3
4
4
2
3
1 6-wire connector
2 2-pin wire receptacle
3 Blue and black cap-sensor switch wires
4 Red RF wires