Hypertherm SmartSYNC 059719, Руководство по процедурам, Страница: 54 / 98

Hand Torch Part Replacement Procedures
4
54 810460 Service Parts and Procedures SmartSYNC
4. Push the pilot arc wire and start-switch wires into the torch handle. Make sure that the routing of
the wires is correct, as shown. Bend the wires as necessary, and use the wire routing studs.
5. Make sure that the torch-lock slider switch on the RF torch PCB is in the lock position.
6. Put the torch-lock slider on the torch-lock slider switch, with the yellow lock ( X ) label pointing to
the torch body. Make sure that the torch-lock slider switch aligns with the recess in the bottom
of the torch-lock slider.
7. Hold the torch-lock slider in position and push the RF torch PCB fully into the torch handle.
1
2
1 Pilot arc wire 2 Start-switch wires
1
2
3
1 Torch-lock slider
2 Recess in the torch-lock slider
3 Torch-lock slider switch