HMC
Administrator’s Guide
9
Hardware and Installation
Release 3.4: May 2010
Installation
System without a CB Card
If the system does not have a CB card, connect the D-Link Router cables as follows:
a.
Attach Port 1 of the D-Link Router to the MG card’s port marked ETHERNET.
b.
Attach Port 2 of the D-Link Router to the PC card’s port marked LAN.
Figure 4: D-Link Connection for System with CB Card
c.
Connect the D-Link’s WAN port to an appropriate network port.
2.
Plug in the router and wait until its Status LED starts blinking green. This indicates that
the unit is functioning properly. A prolonged steady green light indicates a problem.
3.
Configure the router.
a.
Get the following information from your Internet Service Provider:
•
WAN IP Address
•
WAN Subnet Mask
•
WAN Gateway,
b.
Using a computer connected to the same LAN as the Hypermedia Gateway, open a
browser.
c.
Configure the computer to automatically accept its IP address. This is done via the
Windows Network Connections tool. (Refer to Windows on-line Help and search for
DHCP.)
d.
Enter the IP address of the DIR-100 into a browser’s Address field and press “Enter.”
The default IP address on a system using a CB is 192.168.9.254. The default IP
address on a system using a PC is 192.168.0.1. The Log In screen is displayed.
e.
Enter the username
admin
and the password
hypergateway
.
f.
Click
Log In
. The Setup Wizard is displayed.
g.
Click
Manual Internet Connection Setup
.
To PC Card
To MG Card
Содержание HG-4000 3U
