INSTALLATION INSTRUCTIONS
CSC-GW-CWC
SmartCast
®
Wireless Gateway
Includes: T-Bar Mounting
LPN00584X0001A0_A
1 of 2
1
Insert Electrical
Wire
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant l’installation.
2. Must be installed in accordance with the NEC or your local electrical
code. If you are not familiar with these codes and requirements, consult a
qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique
local. Si vous n’êtes pas familier avec ces codes et ces exigences, veuillez
contacter un électricien qualifié.
3. Indoor use only and Suitable for Damp Locations.
Pour usage interieur seulement et convient aux emplacements humides.
4. This equipment shall be installed and operated with a minimum distance 20cm
between the radiator and your body.
L’équipement doit etre installe d’une facon qu’une distance minimum de 20cm
soit maintenue entre l’emetteur et toute partie du corps.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
• Suitable for use in other Environmental Air Space
(Plenums) in accordance with section 300.22,(C) of the
National Electrical Code, and Sections 2-128, 12-010(3)
and 12-100 of teh Cnadian Electrical Code, Part 1 CSA
C22.1
Peut être utilisé dans de gaines transportant de
l’air traité, conformément à la section 300.22,(C) du
National Electrical Eode et aux articles 2-128, 12-010(3)
ET 12-100 du Code Candian de l’électricité Premiére
partie, CSA C22.1.
• Plenum rated cables need to be used when the SWG is
installed in a plenum.
• SWG needs to connected to PoE networks without
routing to outside plant connections.
NOTE:
• Not for use with equipment that requires constant power or equipment that
presents a hazard if automatically energized. Devices requiring soft shutdown
(such as computers) or other power related requirements (such as projectors,
DVRs or Clocks) may not be compatible.
INSTALLATION
STEP 1:
Insert electrical wire into the back of the SWG unit. See
Figure 1.
NOTE:
Plenum rated cables need to be used when the SWG is installed
in a plenum.
STEP 2:
Insert the T-Bar clip into the back of the SWG unit using provided screw
as shown in
Figure 2.
STEP 3:
Attach to T-Bar ceiling by spreading the clip arms apart to appropriate
width and snap the clip onto the T-Bar. See
Figure 2.
2
T-Bar Clip
Arms
T-Bar Clip
Screw
Back of the SWG Unit
