MultiSystem 5060
Operating Instructions Manual
© Hydrotechnik GmbH • All rights reserved
Rev. 1.8/120307EN
Page 20 of 55
6.2.2 Available
functions
START: starts the recording of measurement data; the configu-
rations from the memory menu (channel selection, storage
time, scan rate, a.s.o.) are applied
SHOW: opens the submenu for the presentation and printing of
measurement data
DELETE: opens the submenu to delete measurement data
USTICK: opens the submenu with the USB stick functions
Start a recording
After initiating the recording by pressing F1 a dialog will be displayed,
where the defined recording parameters (selected channels, recording
time, trigger, …) are shown. The device proposes the current date and
time as name of the measurement series.
Meas. series x
name of the measurement series; press ENT to
overwrite the proposal
File name
here you may enter a (different) name for the
measurement series data file
Mode choose
from:
SINGLE
the defined recording parameters will be applied
to execute one single recording
CYCLIC
the defined recording parameters will be applied
to execute a recording; then the recording will be
repeated until the key C-STOP (F3) is pressed
SINGLE VAL
the current value of each selected channel will
be recorded when F4 (TRIG) is pressed
Press F1 if you want to assign a comment to the recording. Start the
recording with F5.
Open presentation menu
See the explanations in section 6.9 on page 37.
Use delete function
See the explanations in section 6.10 on page 41.
Use an USB stick
See the explanations in section 6.11 on page 42.
6.3 Submenu
“Channels”
The MultiSystem 5060 offers 24 channels:
Ch1 ... Ch8
measuring channels; sensor connectors at the rearside
of the device
Ch9 trigger
input
Ch10 trigger
output
Ch11 ... Ch24 special channels
Press
to highlight a chanel. Press to switch between the two
pages of the submenu. The second page contains channels 13 to 24.
6.3.1 Configure
measuring
channels (Ch1 ... Ch 8)
Note
Measuring channels must only be configured if you use sensors
without ISDS capabilities.