HydroQuip BES6000-HC Series, Руководство по эксплуатации и установке

Страница: 5 / 22

10.
WARNING - the equipment system may be equipped with a ground fault circuit
interrupter (GFCI), mounted on the electrical control box. This GFCI protects against
electrical shock hazard by sensing electrical fault conditions and interrupting the
electric power applied to the equipment system.
Before each use of the tub the GFCI, if provided, should be tested in the following
manner: Turn electric power on, Push the test button. The reset button should pop
outward, indicating that the GFCI is functioning properly. Push the reset button all
the way in, restoring electrical power to the equipment system. If the reset button
does not pop outward when the test button is pushed, a loss of GFCI protection is
indicated. Should this occur, immediately disconnect electrical power from the
equipment system, and discontinue use of the tub until a qualified technician has
identified and corrected the problem.
11.
DANGER - risk of electrical shock. Install at least 5 feet (1.5m) from all metal
surfaces. A tub may be installed within 5 feet of metal surfaces if each metal surface
is permanently connected by a solid copper conductor attached to the wire connector
on the control box that is provided for this purpose. A pressure wire connector is
provided on the control box to permit connection of a minimum No. 8 AWG (8.4mm)
solid copper bonding conductor. The bonding conductor should not be smaller the
service conductors supplying the equipment. Connect this point to any metal
enclosures of electrical equipment, metal water pipes, or conduit within 5 feet (1.5m)
of the unit as needed to comply with local requirements.
SAVE THESE INSTRUCTIONS
85-0130 REV.10 5/11
4