HydroQuip BES6000-HC Series, Руководство по эксплуатации и установке, Страница: 16 / 22

SYSTEM INTERFACE RECEPTACLE & MODULE
ystem Interface Module is
stalled.
SYS
These indic rs system.
•
HEATE
•
PUMP “ inated whenever the system pump is activated.
•
HIG L ripped
o
trips repeatedly do not use until corrective service is
performed
Illuminated when the system has been mis-wired
o
This is an indication the 120V has been sent up the Neutral line and is a
IMECLOCK (IF EQUIPPED)
Pro
sh
the teet s
of opera switch under the timer and are as follows:
1. Timed Heat Mode: The sed on the setting of the timer
2. Thermostatic Heat Mod off with relation to the
mp will activate to
SYSTEM START-UP
nto
otherwise directed by the manufacturer.
or serious
amage to the heater and/or pump may result which can void the warranty.
ssary to press and release the red GFCI Reset button.
IMPORTANT NOTE : It is most importa rated for several minutes
to insure that all air has been removed from the system before the heater is allowed to
perate. Only after full water flow has been established should the thermostat be turned
Provides for operation of Auto-Fill & Auto-Drain options when S
in
TEM DIAGNOSTIC CENTER
ato provide real time diagnostics of the
R “ON” – Illuminated whenever the heater is activated
ON” – Illum
•
SYSTEM FUSE – Illuminated when the main system fuse is blown
o
Possible indication of pump issue.
H IMIT TRIPPED – Illuminated when the High-Limit safety switch is t
If the switch
•
SYSTEM MIS-WIRE –
protective feature. Have an electrician correct the issue to allow
operation.
T
vide timer control over heating and filtration cycles. To activate a timed cycle pu
h on the timer outward, each tooth represent 2 hours of operation. The (2) mode
tion are based on the rocker
system heats and filters ba
e: The pump comes on and
thermostat. If a timed cycle occurs outside a heat call the pu
provide additional filtration.
1. Turn the thermostat located on the control box to the off position.
2. Open all water valves, if equipped, on the inlet and/or outlet to allow water to flow i
the equipment system.
3. Fill the tub to within 8” to 9” of the top, or as
CAUTION : The equipment system must never be operated without water
d
4. Check all plumbing connections for leaks.
5. With the thermostat in the off position, apply power to the control box.
Note: if the control box is equipped with a ground fault circuit interrupter, it may be
nece
nt that the pump be ope
o
up.
85-0130 REV.10 5/11
15