HydroQuip BES6000-HC Series, Руководство по эксплуатации и установке, Страница: 15 / 22

Test the GFCI as follows:
1. With the power on, push the test button; the reset button should pop out.
aution - If the GFCI fails to operate in this manner, do not use the tub until a qualified
has corrected the problem.
HERMOSTAT
hen the equipment is operating, the thermostat will control the heater. Initially, adjust
er
ming
e length of time it takes the water to reach desired temperature depends on several
only.
hey do not reflect the actual water temperature. Remember that a small change on the
d a difference of several degrees, so make small adjustments until you find
our preferred temperature. Allow several hours between adjustments for temperatures
EATER
d with a
afety pressure switch that monitors water flow.
The heater operates on demand at the power levels indicated in the table below. It will
shut off when th
e wa to flo
Model Heater Voltage Heater Watts Breaker Size
C
service technician
1. To restore power, push the red reset button in.
T
Setting the thermostat controls the temperature of the water. The thermostat is located
on the front of the control box.
W
the thermostat knob to the middle of the “Comfort Zone.” This setting will cause the wat
temperature to rise to approximately 80F (27C). Do not expect to feel hot water co
from the jets.
Th
factors: water temperature at start, ambient air temperature, tub capacity, relative
humidity, type and insulating qualities of a cover and the consistency of electric power
applied.
Any graduations on the scale around the thermostat are intended for reference
T
dial will yiel
y
to stabilize. Use an accurate thermometer to monitor the water temperature.
H
The stainless steel housing contains an electrical heating element and is fitte
s
e thermostat setting is reached or th ter ceases w.
BES-6005/T-HC 208-240 V 11.0 kW 60-80A
he purpose of this switch is to shut off the heater if the water temperature within the
eater reaches a factory-set, non-adjustable limit. After the water cools sufficiently, push
reset. If the switch trips repeatedly, do not use the tub until the problem has been
entified and corrected by a qualified service technician.
BES-6000/T-HC 208-240 V 5.5 kW 40-50A
HIGH LIMIT
T
h
to
id
85-0130 REV.10 5/11
14