Page 12
Hydro Systems Co. 2018
6.4 User Screens
6.4.1.
In normal mode the unit will show the home screen detailing which formula has been selected. If the user has navigated
to any other part of the menu then after 5 minutes the unit will revert back to the home screen. Once a particular formula
has finished the unit will then revert back to Formula 1 or other select formula (see 6.5.6.2).
6.4.2.
In relay mode the home screen will just say ‘RELAY’ and only show the functionality that has been enabled in the ‘Edit
settings’ screen.
6.4.3.
Again it is advisable to refer to the menu structure at the end of this section when navigating through menus, until you
are familiar with them.
6.4.4. Maintenance Mode
Maintenance Mode (Firmware V1.37 onwards): The EvoClean now includes a ‘maintenance mode’ that can be navigated
to from the home screen (as per above).
When maintenance mode is activated the LED on the unit and RFS will flash and ‘maintenance mode’ will be displayed
on screen. When activated the unit will not accept any trigger signals, it will also not operate any solenoids or any other
functions. It will remain active until deactivated by the user.
Note:
When in maintenance mode the unit remains powered throughout. No covers should be removed. Unit must be electrically
isolated before covers are removed.
6.5 Setup and Programming Step 1: Program Controller
To begin setting up the EvoClean the installer needs to:
Enter setup > Enter passcode (Default = 1234) and the
following screens will then be accessible.
The interface has been designed to allow easy and simple
intuitive programming. It is recommended that the unit is
setup in the following order.
User Screens?
Back
i
h
Yes
Machine Size
Back
i
h
Set
Operational Mode
Back
i
h
Set
Edit Products?
Back
i
h
Yes
Edit Formulas?
Back
i
h
Yes
Edit Settings?
Back
i
h
Yes
Содержание EvoClean 1214GB
Страница 20: ...Page 20 Hydro Systems Co 2018 7 4 Setup Screen ...
Страница 21: ...Page 21 ...
Страница 24: ...Page 24 Hydro Systems Co 2018 ref 2 detail ...
