Hydro-Gear 310-1500, Руководство по обслуживанию и ремонту

Страница: 27 / 48

-1500/-1700 IHT 25
INPUT SHAFT ASSEMBLY
Refer to Figure 19.
DISASSEMBLY
1. Drain the oil from the transaxle by opening
the fi ll port or level port and positioning the
unit so the oil drains. If equipped, open the
oil drain port. See page 6 for location.
2. If replacing the input shaft only, continue
with step 3. If further disassembly of the
unit is required, leave the input shaft in
the transaxle at this time and proceed to
the next page.
3. Remove the snap ring (7), input shaft lip
seal (5), and spacer (4).
4. Remove the input shaft assembly which
con sists of the input shaft (12), ball bear-
ing (8) and retaining ring (6).
5. Remove washer (13) from the input shaft
bore.
INSPECTION
1. Inspect bearing (8) for damage and, if
nec es sary replace bearing, remove wire
re tain ing ring (6) and bear ing (8) from in put
shaft (12).
ASSEMBLY
1. Carefully install washer (13) onto top of
spring in the input shaft bore.
2. Press bear ing (8) onto in put shaft (12) and
secure by in stall ing wire retaining ring (6).
3. Install input shaft assembly (items 12, 8 and
6) into input bear ing bore of main housing
(1).
4. Install spacer (4) into the input bearing
bore.
5. Install the input shaft lip seal (5). See page
25.
6 Secure in put shaft as sem bly (12) by in-
stall ing re tain ing ring (7).
7. Fill the unit with new motor oil. See page
11.
Figure 19. Input Shaft Assembly
REF. Part Name
1 Main Housing
4 Spacer
5 Lip Seal
6 Wire Retaining Ring
7 Snap Ring
8 Ball Bearing
12 Input Shaft
13 Block Thrust Washer