Hyd-Mech S-20 Series II, Руководство пользователя

Страница: 9 / 59

PG 2.1
SECTION 2A, SECTION 2A,
SECTION 2A, SECTION 2A, SECTION 2A,
CONTROL CONSOLE CONTROL CONSOLE
CONTROL CONSOLE CONTROL CONSOLE
CONTROL CONSOLE
OPERA OPERA
OPERA OPERA
OPERATTTTTOR CONTROL P OR CONTROL P
OR CONTROL P OR CONTROL P
OR CONTROL PANEL ANEL
ANEL ANEL
ANEL
The operator control panel provides the operator with all the controls necessary to operate thesaw
after the cutting angle has been set and the stock has been loaded and secured. All of the electrical
functions and the Feed Rate setting are operated from the control panel.
HOLD: - Stops and holds the Head at position.
FEED: - The Head will descend at the rate set by the
Feed Rate knob. This rate can be set on the scale
of 1 to 10. As the number increases so does feed
rate.
DOWN: - Allows for rapid approach of the blade to the
workpiece.
Oper Oper Oper Oper Operaaaaator Contr tor Contr tor Contr tor Contr tor Control Console ol Console ol Console ol Console ol Console
START Button - This button starts the saw blade.
The blade will not start with the
Head in the down position.
STOP Button - Pressing the RED mushroom button
will STOP the blade.
COOLANT Switch - OFF: No coolant flow.
ON: Coolant flow when blade is
running
WASH: Constant flow
FUSE - Check if power fails.
Twist & pull to remove fuse.
ELECTRICAL CONTROL ELECTRICAL CONTROL ELECTRICAL CONTROL ELECTRICAL CONTROL ELECTRICAL CONTROLSSSSS
HYDRA HYDRA
HYDRA HYDRA
HYDRAULIC CONTROL ULIC CONTROL
ULIC CONTROL ULIC CONTROL
ULIC CONTROLSSSSS