Hyd-Mech S-20 Series II, Руководство пользователя

Страница: 19 / 59

PG 3.3
BL BL BL BL BLADE TRA ADE TRA ADE TRA ADE TRA ADE TRACKING ADJUSTMENT CKING ADJUSTMENT CKING ADJUSTMENT CKING ADJUSTMENT CKING ADJUSTMENT, , , , ,
CONTINUED CONTINUED CONTINUED CONTINUED CONTINUED
10B. Drive Wheel Adjustment. -- On the wall behind the drive wheel are two adjusting bolt
assemblies and two hex bolts. Loosen all four of them with a 3/4" socket and turn the larger hex
head bolts 1/4 turn with a 1 1/8" socket and extension and then tighten the two bolts in the
assemblies, then tighten the two hex bolts et the left. Turning the 1 1/8" bolts clockwise will pull
the blade on to the wheel and turning counter clockwise will push the blade off. Each 1/4 turn
will move the blade approximately .02".
Driv Driv Driv Driv Drive wheel tr e wheel tr e wheel tr e wheel tr e wheel trac ac ac ac ackkkkking ing ing ing ing
bolt assemb bolt assemb bolt assemb bolt assemb bolt assemblies lies lies lies lies.....
11. Check the blade brush adjustment (Pg 3.4) to be sure the blade is being cleaned properly.
BL BL BL BL BLADE GUIDE ADJUSTMENT ADE GUIDE ADJUSTMENT ADE GUIDE ADJUSTMENT ADE GUIDE ADJUSTMENT ADE GUIDE ADJUSTMENT
At the bottom of the guide arms are the carbide blade guide assemblies, the photo below shows
the carbide locking handle. These assemblies will need to be adjusted occasionally as the carbide pads
become worn. To adjust properly, follow this simple procedure. Loosen the hex nut on the locking handle
with a 9/16 wrench and turn the handle clockwise until it rests against the coolant tap on the idler guide
arm or the roll pin on the drive guide arm. Turn the set screw clock wise with a 3/16 allen key until tight
and then loosen 1/8 of a turn and tighten the hex nut. This should put just enough pressure on the blade
to permit you to push the blade down approximately 1/8".
Idler guide arm carbide Idler guide arm carbide Idler guide arm carbide Idler guide arm carbide Idler guide arm carbide
loc loc loc loc lockkkkking handle in the ing handle in the ing handle in the ing handle in the ing handle in the
loc loc loc loc lockkkkked position. ed position. ed position. ed position. ed position.