Hyd-Mech S-20 Series II, Руководство пользователя

Страница: 20 / 59

PG 3.4
ANGLE BRAKE ADJUSTMENT ANGLE BRAKE ADJUSTMENT ANGLE BRAKE ADJUSTMENT ANGLE BRAKE ADJUSTMENT ANGLE BRAKE ADJUSTMENT
The clamping force on the swivel brake can be adjusted to ensure that the Head is held securely
and does not move during cutting. The brake handle should be adjusted so that it does not "bottom out"
or hit it's movement limit, yet holds the head securely.
Ang Ang
Ang Ang Angle Br
le Br
le Br le Br le Brak
ak
ak ak ake Adjustment Scr
e Adjustment Scr
e Adjustment Scr e Adjustment Scr e Adjustment Screeeeews
ws
ws ws ws
ANGLE BRAKE ADJUSTMENT PROCEDURE ANGLE BRAKE ADJUSTMENT PROCEDURE
ANGLE BRAKE ADJUSTMENT PROCEDURE ANGLE BRAKE ADJUSTMENT PROCEDURE
ANGLE BRAKE ADJUSTMENT PROCEDURE
STEP 1 Loosen locking cap screws "B" with a 1/4 allen key.
STEP 2 Tighten all 4 set screws "A" until snug with a 5/32" allen key.
STEP 3 Back out the "A" screws 1/4 of a turn.
STEP 4 Tighten the locking cap screws "B".
STEP 5 Swing the head to 45 degrees and back to ensure that the head moves freely and
does not bind on the pivot surfaces. Continue to step 6 if necessary.
STEP 6 Adjust the clamping force bolt "C" with a 3/4" wrench. If not tightened enough, the
locking handle will "bottom out" and not hold the head firmly.
BL BL BL BL BLADE BR ADE BR ADE BR ADE BR ADE BRUSH ADJUSTMENT USH ADJUSTMENT USH ADJUSTMENT USH ADJUSTMENT USH ADJUSTMENT
The S-20 Series II leaves the factory with the blade brush adjusted for maximum life of the brush.
This setting places the ends of the blade brush wires so as to contact the blade at the bottom of the
blade gullets. The plastic drive wheel that is driven by the drive wheel face should be held against the
blade face with the minimum force that is necessary. As the blade brush wears it is necessary to
periodically adjust it closer to the blade or if a new brush is installed, further away from the blade.
As shown below, there are two springs on socket head screws holding the brush assembly against
the blade. There is also an adjusting socket set screw with a hex nut on it. Loosen the hex nut with a 9/16"
wrench and turn the set screw counter clockwise with a 3/16" allen key. This will move the brush closer to
the blade. Adjust the set screw so that the brush cleans to the bottom of the blade gullets and tighten the
hex nut.
Blade br Blade br
Blade br Blade br
Blade brush ush
ush ush
ush
adjusting scr adjusting scr
adjusting scr adjusting scr
adjusting screeeeew w
w w
w.....
C CC CC
B BB
BB
A AA
AA