Hyd-Mech S-20 Series II, Руководство пользователя

Страница: 7 / 59

PG 1.4
Coolant R Coolant R Coolant R Coolant R Coolant Return (Shown with tank r eturn (Shown with tank r eturn (Shown with tank r eturn (Shown with tank r eturn (Shown with tank remo emo emo emo emovvvvved) ed) ed) ed) ed)
LEVELLING THE SAW LEVELLING THE SAW LEVELLING THE SAW LEVELLING THE SAW LEVELLING THE SAW
Use a machinist's level across the vise table to level the saw. Adjust the level with the levelling
bolts supplied. Consideration should be given to the flow of the coolant as it returns to the coolant
trough at the vise end of the saw. Levelling to give a small incline towards this area helps to ensure the
coolant supply returns to the container.
W W W W Wash Down Hose ash Down Hose ash Down Hose ash Down Hose ash Down Hose
Coolant Pump Coolant Pump Coolant Pump Coolant Pump Coolant Pump
PO PO
PO PO POWER WIRING CONNECTIONS
WER WIRING CONNECTIONS
WER WIRING CONNECTIONS WER WIRING CONNECTIONS WER WIRING CONNECTIONS
When the machine has been anchored and levelled the power hook-up is the last installation step.
In order to provide safe operation and to prevent potential damage to the machine, only qualified
personnel should make the electrical connections.
As supplied your new S-20 Series II is set to run on three phase voltage. The supply voltage of the
machine is displayed on the Serial # Plate and the Voltage Label. Connection from the Main supply is
made to L1, L2, L3, ( at the Motor Contactor ) and Ground ( at the Ground Lug ).
Supply conductors should be rated for the current supplied and should be protected by time delay
fusing rated for the amperage stated on the machine serial plate
CHECK FOR: -Signs of damage to the electrical cables from shipping or installation.
-Correct phase order - The blade should be running counter clockwise.
( If the blade direction is wrong, two lines should be reversed to correct )
Ground
L1 Motor Contactor
L2
L3
PPPPPow ow ow ow ower Wiring to the Motor Contactor er Wiring to the Motor Contactor er Wiring to the Motor Contactor er Wiring to the Motor Contactor er Wiring to the Motor Contactor