Huvema HU 300 HAC-4 Topline, Инструкция по эксплуатации

Страница: 55 / 86

54
20.1 malfunctions in the machine
A * Electric motor does not (for the blade) 3-4-5-9
B * Electric motor does not (for hydraulic unit) 1-2-3-4-5-9-17
C * Electronic control will not turn on 6-7-8-9
D * hydraulic circuit not under pressure 10-11-12-13
E * hydraulic pump runs noisily 14-15-16-17
F * coolant is missing or not enough 18-19-20-21
G * sawing material moves or deforms 22-23-24
H * The cycle does not start 23
List of parts to be verified
1 = plug is not properly inserted in the socket
2 = main switch Not switched
3 = Motor Blown or damaged
4 = Power supply incorrect
5 = Drive is disabled (galling, rust, etc.)
6 = fuse on the transformer primary winding
7 = fuse on the secondary winding of the transformer
8 = transformer damaged or blown
9 = terminals of the supply lines
10 = oil level in the tank
11 = leaks in pipes or fittings
12 = adjusting the high pressure valve loose
13 = high-pressure valve defective
14 = quality of hydraulic oil (used to liquid)
15 = Water in oil and / or condensate in the bowl
16 = pressure too high (above 20 BAR) circle
17 = hydraulic pump blocked (seizure, expansion, oxidation)
18 = circuit valves closed
19 = coolant filter clogged or clean
20 = coolant pump does not work (see 3-4-5-9- 24)
21 = container empty or dirty
22 = Excessive cutting feed
23 = vice insufficiently closed workpiece poorly clamped
24 = The switch for minimum quantity lubrication is off
20.2 error on tape / Causes / Solutions
When broken teeth, broken bands or insufficient The life of the belt
lay broken tape on the floor, the defects on the belt body and to the