Huvema HU 300 HAC-4 Topline, Инструкция по эксплуатации

Страница: 39 / 86

38
Thanks to the teeth with alternating pitch (ie alternately small and larger teeth)
allows the built-in band saw blade, different sized to cut work pieces. One must,
however, one of the best for the material
Being cut Use a suitable saw blade to the performance of the machine properly
exploit.
For proper use of the band saw blade section choice is
be read carefully.
By depressing the lever is located on the left (4) and withdraw the
Vise the vise open quickly.
Place the work piece to be cut on the countertop, the vise forward
push and approach the work piece.
The left lever release (4) to lock the thread switching again. it should
engage not good, the front wheel (3) is easy to rotate in both directions.
This 2 - 3 mm of play between the work piece and the clamping jaws (for automatic
Clamping device necessary) let.
It is also possible the whole vise from one side to the other
to lay side of the worktop, so that he is not in the line of intersection,
eg for miter cuts. To carry out this work No material shall not be trapped.
for this purpose, loosen the lower clamp lever (1) and the vice desired in the
direction of slide. When the desired position is reached, the clamping lever