Huvema HU 300 HAC-4 Topline, Инструкция по эксплуатации

Страница: 47 / 86

46
Squareness of the saw band between band and worktop :
This setting is very important and ensures together with the belt tension the
Implementation of straight cuts. In this case, set the table to 0 °, the chuck
fully open and set the saw arm upward. A very precise 90 °
Set angle on the counter (next to the jaws) and the saw band Create (in a
position where the teeth contact not interfere).
Lower the saw arm to the cut end, while holding the angle well and assess
visually inspect whether the band saw blade moves away from the
approaching him.
The saw arm back up again and then reset the angle to the back operator
that the band saw blade to the upper end of the angle approaches. The
bracket again Lower until the cut end, while holding the angle well .
Usually you can find any geometric errors with this test, but it serves to
define still more as to whether the cause of odd sections of external factors
outside of the machine dependent (eg worn saw blade,
incorrect voltage, gearing errors and excessive cutting force).
SPRINGS
It may be necessary to tighten the retaining springs rear of the saw arm f or
this purpose.
Loosen the two screws securing the skid plate, the rear screw rotate and