Huvema HU 300 HAC-4 Topline, Инструкция по эксплуатации

Страница: 38 / 86

37
end of the up ward movement again on "open" turn to the material for the next
cycle start clamp.
Selector saw frame:
This switch is used to raise and lower the saw frame.
1) When the selector switch to " Lift the saw frame” is rotated, moves the
Saw arm in the "Rapid traverse" as long as this is activated upwards. If the
Switch operated during the saw cut, the cycle is interrupted.
2) When the selector switch to " Reduce saw frame” is rotated, moves the
Saw arm in the "Rapid traverse" as long as this is activated down. Should the
Cause material detection button, switches the "Rapid traverse" and an
Downward movement is above the value set on the feed regulator determined.
Speed selector switch
This switch is used to adjust the speed of the saw blade motors (37-0 -74 m / min),
for machines with frequency, the speed continuously (25 -90 m / min) can be
adjusted.
Ammeter
With the ammeter, the current consumption of the saw blade motors is displayed,
it is helpful to the correct feed rate set or showing it worn saw blade to a higher
value.
14.2 Preparing to section