HUSTLER Super Z HD, Общее руководство по обслуживанию, Страница: 32 / 50

REV C 6-2 117592
11. Push or pull on the deck lift foot pedal until the chain on
the left front just becomes tight, making sure that the
deck stays tight against the block.
12. While keeping the chain tight, tighten the nuts against the
deck lift block on the height indicator rod, just enough to
carry most of the deck weight on that side — the block
should be able to move with only a slight drag. Figure 6-5
13. Jam nuts tightly together against the deck lift block.
14. Go to the right front of the mower.
15. Loosen the 5/16” jam nut on the adjuster lift chain, and
back the adjuster bolt out to allow the adjuster to move
up and down freely. Figure 6-6
16. Tighten the adjuster bolt until the chain just becomes
tight. Then tighten just enough to carry the weight of the
front of the deck on that side—to check, move the blocks
back and forth; they should move with a slight drag.
Figure 6-6
17. Tighten the adjuster bolt jam nut to prevent the adjuster
bolt from moving. Figure 6-6
18. Tighten the hardware holding the chain and adjuster onto
the deck lift arm. Figure 6-6
19. Go to the right rear of the mower.
20. Make sure that there is still slack in the chain. If not,
loosen the two nuts on the block holding the threaded rod
until there is slack in the deck lift chain.
21. Tighten the appropriate nut until the chain just becomes
tight, and carries most of the deck weight. Check by
moving the block—it should move with a slight drag.
Figure 6-7
22. Tighten the other nut on the opposite side of the block,
and jam them tightly together against the block.
23. Go to the left rear of the mower.
24. Make sure that there is still slack in the chain. If not,
loosen the two nuts on the block holding the threaded rod
until there is slack in the deck lift chain. Figure 6-8
25. Tighten the appropriate nut until the chain just becomes
tight, and carries most of the deck weight. Check by
moving the block—it should move with a slight drag.
Figure 6-8
26. Tighten the other nut on the opposite side of the block,
and jam them tightly together against the block.
27. Compress the deck lift assist springs so that there is 1”
(25.4mm) of space between the front nut on the spring
and the rear nut on the deck lift block. Typical both sides.
Figure 6-5
28. When completed, all chains will be tight, and deck
Figure 6-4
Figure 6-5
Foot pedal
Nuts
Deck lift rod
Lift block
1”
1”
Figure 6-6
Figure 6-7
Hardware
Adjuster
Jam nut
5/16” bolt
Chains
Nuts