HUSTLER Super Z HD, Общее руководство по обслуживанию, Страница: 31 / 50

117592 6-1 REV C
DECK ADJUSTMENTS
Deck Leveling
Leveling the deck must be done in the following manner and
order:
1. Check tire pressures to make certain they are properly
inflated before starting to level deck. The recommended
pressures are as follows:
Drive wheels . . . . . . . . . . . . . . . 8-12 psi (55-83 KPa)
Front wheels . . . . . . . . . . . . . . . . 8-12 psi (55-83 KPa)
2. Park the unit on a flat surface.
3. VX4 Side Discharge Decks – Place 3” high deck support
blocks (two stacked 2” x 4” blocks can be used to create a
3” [76.2mm] high support) at the four corners of the deck
marked with the locator triangle as shown. Figure 6-1
NOTE:
Back of deck will automatically be set 1/4”
(6.35mm) higher.
Rear Discharge Deck (all) (Figure 6-2) – Place two
3.75” (95.3mm) high deck support blocks (two stacked
2” x 4” blocks and one 1” x 4” can be used to create a
3.75” [95.3mm] high support) at the front of the deck as
shown. Place two 3” high deck support blocks (two
stacked 2” x 4” blocks can be used to create a 3”
[7.62cm] high support) at the sides of the deck as shown.
4. VX4 Side Discharge Decks – Place the height stop in the
3” (76.2mm) hole, with the pin side of the height
adjusting stop against the stop handle.
Rear Discharge Decks (all) – Place the height stop in
the 3.25” (82.6mm) hole, with the plate side of the height
adjusting stop against the stop handle.
5. Clamp the height adjusting stop against the stop handle.
This will assure that the height will not move during the
setting process. Otherwise, spring pressure from the deck
lift springs will tend to pull the stop away from the
handle. Figure 6-3
6. Loosen all nuts on the deck lift threaded rods, and the
hardware on the height indicator bar (on the right front),
until
all the deck lift chains are loose, and the deck is
sitting tightly on all four blocks. Figure 6-4, Figure 6-5 &
Figure 6-8
7. Loosen the two nuts on the front of height indicator so
that the foot pedal is free. Figure 6-4 & Figure 6-8
8. Start the leveling process on the left front of the mower.
9. Set the amount of threads protruding on the deck lift rod
from the lift block at approximately 1" (25.4mm) (left &
right side). Figure 6-5
10. Jam both nuts against the block.
WARNING
Stop engine. Make sure deck clutch switch is in the down
(OFF) position . Place control levers in the brake position
before leaving machine.
Figure 6-1
Locator triangle
Figure 6-2
Figure 6-3
3.75” Block
60” Rear Discharge Deck shown
3” Block
3” Block
3.75” Block
Stop
handle
Clamp here
Deck adjustment stop