HUSTLER Super Z HD, Общее руководство по обслуживанию, Страница: 24 / 50

REV C 4-12 117592
replaced
b. If sufficient gap is present, then proceed to safety
check outlined below.
Perform safety check:
1. Start the engine and the deck should not be engaged with
the PTO switch “off” and clutch de-energized. Engage
and disengage the PTO switch to ensure the proper
function of the clutch.
2. If clutch still does not engage, then follow the
troubleshooting procedure outlined in Warner Electric
P1177 installation troubleshooting guide available on
Warner Electric’s web site-www.Warnerelectric.com and
consult owner’s manual.
Tires
It is important for level mowing that the tires have the same
amount of air pressure. The recommended pressures are:
Drive wheels . . . . . . . . . . . . . . . . . . . . . 8-12 psi (55-83 KPa)
Front wheels . . . . . . . . . . . . . . . . . . . . . 8-12 psi (55-83 KPa)
If you wish to use non-pneumatic tires on your Hustler ®
mower the tires must be an approved tire purchased from
Hustler
® Turf Equipment. Warranty claims will be denied on
any mower equipped with unapproved non-pneumatic tires.
Figure 4-31
Figure 4-32
WARNING
Observe deck operation from the operator’s seat.
M6 x 1 bolt
Figure 4-33
Figure 4-34