1-18
I
nstallatIon
P/N 3143042_B
U.S. & Canada 1-800-922-1919 • Mexico 800-890-2900 • WWW.HUSSMANN.COM
Insert pin at top
of the door
through Bushing
Seat Torsion rod into plate
assembly. Rotate door
slightly to verify torsion rod
is seated properly
Repeat above steps for all other doors
9. Repeat the steps in the illustrations below
for all doors.
Insert Pin at top of
door through Bushing
Insert pin at top
of the door
through Bushing
Seat Torsion rod into plate
assembly. Rotate door
slightly to verify torsion rod
is seated properly
Repeat above steps for all other doors
10. Use ½"open end wrench to add closing
tension to the door. Typically 4 to 6
clicks is recommended. Do not exceed 6
clicks.
Turn wrench toward the door handle to
increase door tension.
To remove tension from door, lift the door
assembly out of the plate assembly. Do not
attempt to turn rod away from the door handle.
Seat Torsion Rod into
plate assembly. Rotate
door slightly to verify
torsion rod is seated
properly.
Adjust torsion rods
Use ½” open end wrench to add closing tension to the door. Typically 4 to 6 clicks is recommended .
Do not exceed 6 clicks.
Turn wrench toward the handle of the door
Step #1
Step #2
- Insert Wiper retainer at an angle into bottom extrusion as shown in step #1
- Squeeze the wiper retainer and insert into bottom extrusion as shown in step #2
Squeeze
Wiper retainer
Bottom
Extrusion
Outside of
case
11. Insert wiper retainer at an angle into
bottom extrusion as shown in Step #1
Squeeze the wiper retainer, and insert into
bottom extrusion as shown in Step #2.
Wiper Retainer
Squeeze
Bottom
Retainer
Step #1
(Outside of
Case)
(Outside of
Case)
Step #2
