Hussmann Smart Exchange, Руководство по установке и эксплуатации

Страница: 7 / 70

HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
P/N 3110238_B 1-1
Smart Exchange Food Lockers
SPECIAL INSTALLATION REQUIREMENTS
Consult with the appropriate structural design professional for special installation requirements in your area for
conditions not covered by this design. See below.
•
Sites where an active fault could cause the ground to rupture at the surface
•
Sites defined as Site Class F in ASCE 7-16, Chapter 20 (poor or liquefiable soil). These sites
require a site response analysis to be performed by a Geotechnical Engineer in order to determine the Sds
value, per ASCE 7-16 Section 11.4.7
•
Sites where the refrigerated modules are installed above ground level
•
Mountaintop sites in Hawaii where the effective design wind speed (per ASCE 7-16 Figure 26.5-2B) exceeds
180 mph
•
Sites in Florida or Southeast Louisiana where the locker assembly has an unobstructed view of an
ocean or large lake and / or wind speeds right on the coast/beach can exceed the rated capacity of the locker
assembly’s anchorage
•
Sites where both Kzt > 1.5 and V > 145 mph per ASCE 7-16, Section 26.8. This would be sites where the
locker assembly will be sitting on the top of, or face of, any terrain feature (hill, ridge, escarpment, etc.)
with a slope greater than 1:10 in any of the following regions. For reference, 1:10 slope is about the maxi-
mum possible for pushing wheelchairs or riding bicycles.
•
Florida south of Orlando
•
Within 50 miles of the Gulf of Mexico
•
North Carolina or South Carolina within 10 miles of the ocean
•
Installations in hurricane zones
INSTALLATION