Hussmann Smart Exchange, Руководство по установке и эксплуатации

Страница: 3 / 70

HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
P/N 3110238_B iii
Smart Exchange Food Lockers
This manual was written in accordance
with originally perscribed components that
is subject to change. Hussmann reserves
the right to change all or parts of the locker
assembly for future stores such as, but not
limited to, controllers, refrigeration and
electrical specifications and requirements.
Personal Protection Equipment (PPE)
Only qualified personnel should install and
service the locker assembly and / or compo-
nents. Personal Protection Equipment (PPE)
is required whenever servicing any components
of the locker assembly. Wear safety glasses,
gloves, protective boots or shoes, long pants,
and a long-sleeve shirt when working with the
locker assembly. Observe all precautions on
tags, stickers, labels and literature attached to
the locker assembly.
Contractors shall strictly adhere to specifi-
cations provided by the Engineer of Record
(EOR), as well as US Environmental Protection
Agency regulations, OSHA regulations, and
all other federal, state and local codes. This
work should only be done by qualified, licen-
sed contractors. There are numerous hazards,
not limited to, but including: burns due to
high temperatures, high pressures, toxic subs-
tances, electrical arcs and shocks, very heavy
weights with specific lift points and structural
constraints, food and product damage or conta-
mination, public safety, noise, and possible
environmental damage.
— LOCK OUT / TAG OUT —
To avoid serious injury or death from elec-
trical shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This in-
cludes, but is not limited to, such items as con-
trollers, electrical panels, condensers, lights,
fans, and heaters.
Proper Field Wiring and Grounding Required!
Failure to follow code could result in death
or serious injury. All field wiring MUST be per-
formed by qualified personnel. Improperly
installed and grounded field wiring poses
FIRE, SHOCK and ELECTROCUTION
hazards. To avoid these hazards, you MUST
follow requirements for field wiring installation
and grounding as described in NEC and your
local/state electrical codes.
Be sure to place the locker assembly on solid
ground and take measures to prevent it from
tipping over. If the ground is not solid or the
place is not appropriate, it may lead to damage
to the locker assembly and personnel injury.
The locker assembly shall not be installed in a
place where flammable or volatile materials are
stored. Otherwise, it may cause an explosion
or fire. It shall not be installed in areas with
acid or corrosive gases. Otherwise, it will
cause leakage or electric shock due to reduced
insulation class arising from the corrosion of
electrical products.