Rev.0303
15
appearance and significantly shortening product shelf life.
Soap and hot water are not enough to kill this bacteria. A
sanitizing solution must be included with each cleaning process
to eliminate this bacteria.
1. Scrub thoroughly, cleaning all surfaces, with soap and
hot water.
2. Rinse with hot water, but do not flood.
3. Apply the sanitizing solution according to Hussmann’s
directions.
4. Rinse thoroughly.
5. Dry completely before resuming operation.
CLEANING GLASS AND MIRRORS
Only use a soft cloth and mild glass cleaner for cleaning
any glass or mirrored components. Be sure to rinse and/
or dry completely.
Never use hot water on cold glass surfaces! It
may shatter and cause serious injury!
Allow glass
surfaces to warm first.
CLEANING PRECAUTIONS
WHEN CLEANING:
TO PRESERVE THE ATTRACTIVE FINISH:
Do Use Water and a Mild Detergent for
the Exterior Only!
Do Not Use Abrasives or Steel Wool Scouring Pads
(these will mar the finish)
Do Not Use High Pressure Hoses
Do Not Introduce Water Faster than Waste
Outlet can Drain
Never Use a Cleaning or Sanitizing Solution
that has an OIL BASE (these will dissolve the
butyl sealants) or AMMONIA BASE
(this will corrode the copper components
of the case)
NON-GLARE GLASS
The high optical clarity of this glass is possible due to special
coatings on the glass surface itself. To preserve this coating
and the optical clarity, keep the glass clean.
Windex
®
or Glass Plus
®
are the only solutions
recommended for use in cleaning non-glare glass. The
damage to the glass from improper, caustic solutions is
irreparable.
In addition to cleaning the glass with the recommended
product, there are precautions that should be taken when
working and cleaning the inside of the case.
•
When cleaning the inside of the cases, we recommend
that the glass be fully opened and covered to prevent
solutions from splashing onto the glass and ruining the
coating on the inside.
PLEXIGLASS and ACRYLIC CARE
Improper cleaning not only accelerates the cleaning cycle
but also degrades the quality of this surface. Normal daily
buffing motions can generated static cling attracting dust
to the surface. Incorrect cleaning agents or cleaning cloths
can cause micro scratching of the surface, causing the plastic
to haze over time.
CLEANING
Hussmann recommends using a clean damp chamois, or a
paper towel marked as “
dust and abrasive free
” with
210
®
Plastic Cleaner and Polish
available by calling Sumner
Labs at
1-800-542-8656
. Hard, rough cloths or paper
towels will scratch the acrylic and should not be used.
ANTISTATIC COATINGS
The
210
®
has proven to be very effective in not only
cleaning and polishing the Plexiglass surface, but also
providing antistatic and anti-fog capabilities. This product
also seals pores and provides a protective coating.
Содержание ASCS
Страница 38: ...IGSV ASCS 0303 38...