Hussmann ASCS, Инструкция по установке и эксплуатации

Страница: 13 / 40

Rev.0303
13
Finishing Touches
JOINT TRIM
After cases have been leveled and joined, and refrigeration,
electrical, and waste piping work completed, install the
splashguards. Fasten along the top edge, or center, with
#10 X 3/3" sheet metal screws.
Joint Trim
Joint Trim
ASCS
Butyl Locations
D
O
N
OT
S
EAL
J
OINT
T
RIM
T
O
F
LOOR
!
BUMPER INSTALLATION TIPS
1. Start to attach the bumper at one end of the lineup,
preferably on a straight case.
2. Push the end of the bumper into the bumper channel
firmly. This may be difficult if bumper is cold.
3. Bend the bumper backwards to open and guide it
forward onto the bumper channel.
4. An inside bumper miter must be cut on wedges.
5. Loose ends on miters must be anchored with screws
on the bottom edge.
6. The top and bottom edges of the bumper must be
firmly seated into the retainer by applying with a
rubber mallet (not by hand).
7. The bumper should be struck by the mallet at a slight
angle that forces the bumper back into itself to
prevent stretching. The installation can be made easier
by applying a paraffin block to the retainer grooves.
INSTALLING SPLASHGUARD
After merchandisers have been leveled and joined, and all
drip piping, electrical and refrigeration work has been
completed, install the splashguards. Splashguards may be
sealed to the floor using a vinyl cove base trim. The size of
trim needed will depend on how much the floor is out of
level. NOTE: The splashguard must be removable to allow
access to components behind it.
1. Remove all dirt, wax, debris, etc. from the area of the
splashguard to ensure a secure adhesion.
2. Apply a good contact cement to the trim, allowing a
proper dry time.
3. Install trim to the splashguard so that it is flush with
the floor.