Husqvarna F2103P4, Руководство по ремонту

Страница: 43 / 343

7.1
Handlebar �osition
101859-10
7 HANDLEBAR,CONTROLS
On the upper triple clamp, there are two holes at a distance
of
6)
to each other.
I
Hole distance
e
115 mm (0.59 in)
The holes on the handlebar supports are placed at a distance
of
0
from the center.
I
Hole distance
0
I 3.5 mm (0.138 in)
The handlebar supports can be mounted in four different posi­
tions.
Adjusting the handlebar position
Warning
Danger of accidents
A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
- Change the handlebar if the handlebar is damaged or bent.
101860-10
- Remove screws
O.
Take off the handlebar clamps. Take off
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam­
age.
Do not bend the cables and lines.
- Remove screws
8.
Take off the handlebar supports.
- Place the handlebar supports in the required position. Mount
and tighten screws
8.
Guideline
M10 40 Nm (29.5 lbf ft)
Loctite
®
243 ™
Info
Position the left and right handlebar holders evenly.
- Position the handlebar.
Info
Make sure the cables and wiring are positioned cor­
rectly.
- Position the handlebar clamps. Mount and tighten screws
0
evenly.
Guideline
Screw, handlebar
clamp
MB 20 Nm (14.8 lbf ft)
41